Frigidaire FFTA0833Q1 Installationshandbuch PDF herunterladen

READ BEFORE INSTALLING UNIT

For Through-the-Wall Air Conditioners

Installation Instructions

DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HERE

Note that the air conditioner dimensions are: 24" wide,14" high, and 19" deep (without front). Install Air Conditioner

according to these installation instructions to achieve the best performance. Save these installation instructions for

future reference.

Do This First (for existing sleeve)

You may not need all parts in the kit. Discard unused parts.

Items in Kit

2020213A1639

Hardware

Tapered Spacer Blocks (17” Long)

Plastic Divider ( )

Stuffer Seal ( )

5 seal ( )

No. Qty.

Centering/Support Blocks ( ” )

4 ” x 3 ” x 1

” x 4 ” x 14 ”

1” x 1 ” x 84”

1” x 1 ” x 25”

seal ( )

1” x 1 ” x 14”

seal ( )

1” x 3/8” x 25”

seal ( )

1” x 3/8” x 14”

seal ( )

1” x 3/4” x 14”

Hardware

Ground Wire (green)

14 Grounding Screw

15 1

16 1

No. Qty.

Trim Frame (top & bottom legs)

Grille (plastic)

Grille Aluminum

Nuts (plastic)

Screw w/washer

Trim Frame (side legs)

Toothed washer for grounding screw

Pay attention to danger and safety notices.

To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may

be exposed:

Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install

the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To

prevent injury or strain, use proper lifting and carrying techniques when moving unit.

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended

period of time.

Handle air conditioner with care.

Make sure air conditioner does not fall during installation.

Carefully read the installation manual before beginning.

Follow each step as shown.

Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.

INSTALLATION WARNINGS AND CAUTION

1 2 3 4 5 6 ... 13 14

Inhaltsverzeichnis

Seite 1 - Installation Instructions

READ BEFORE INSTALLING UNITFor Through-the-Wall Air Conditioners11Installation InstructionsNOTE:DO NOT USE ANY SCREWS OTHER THAN THOSE SPECIFIED HEREN

Seite 2

Installation Instructions#7 WhirlpoolWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace with provided lou

Seite 3

Installation Instructions#8 White Westinghouse/Frigidaire/Carrier 52F SeriesWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of th

Seite 4

Installation Instructions#9 White Westinghouse or FrigidaireWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and re

Seite 5 - Wall Sleeve Brands:

1313Installation InstructionsDirect Unit MountingThe previous directions are the preferable way to mount the new rear grill. The unit’s performance is

Seite 6

Installation InstructionsFINISHING INSTALLATION:14142. Assemble the trim frame by inserting top and bottom pieces into side pieces and snapping

Seite 7 - Tapered Spacer Block

22Installation InstructionsHow to Install1. Identify the wall-sleeve brand for your installation, from the chart below.BrandWall Sleeve DimensionsWid

Seite 8

33Installation Instructions1. Remove the existing grille.2. Place the grille included with the new air conditioner towards the rear of the sleeve.3.

Seite 9

44Installation Instructions#1 EmersonWall Sleeve Brands:1. Remove existing NOTE: You may need to drill holes in flange of existing sleeve to matchnew

Seite 10 - 4.5" 4"

Installation Instructions#2 FeddersWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace with provided louve

Seite 11

Installation Instructions#3 Fedders or FriedrichWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace with p

Seite 12

Installation Instructions#4 General Electric/HotpointWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace w

Seite 13 - Grille &

Installation Instructions#5 Sears or Carrier 51S SeriesWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace

Seite 14

Installation Instructions#6 WhirlpoolWall Sleeve Brands:1. Remove existing rear grille as shown on Page 3 of this manual and replace with provided lou