Frigidaire FGEF302TNF Bedienungsanleitung PDF herunterladen (Seite 10)

SETTING SURFACE CONTROLS

NOTE

See Suggested Element Power Level Settings Table on

page 9.

CAUTION

Radiant surface elements may appear to have cooled •

after they have been turned off. The glass surface

may still be hot and burns may occur if the glass

surface is touched before it has cooled sufﬁ ciently.

Do not place aluminum foil, plastic items such •

as salt and pepper shakers, spoon holders or

plastic wrappings on top of the range when it is

in use. These items could melt or ignite. Potholders,

towels or wooden spoons could catch ﬁ re if placed

too close to the surface elements.

Fig. 1 Fig. 2

Fig. 5

Fig. 3

Fig. 6Fig. 4

Hot Element Indicator Message

After using any of the radiant element positions the

cooktop will become very hot. Even after setting the

controls to OFF, the cooktop will remain hot for some

time. The cooktop control monitors the temperature

of the cooktop and displays the message "HE" (hot

element) warning when the cooktop is still too hot to

touch. If the HE message appears in the window, the

control can still be turned on again for use.

To Operate the Dual Radiant Elements:

1. Place correctly sized cookware on the dual radiant

element.

2. To activate press and hold the keypad for the

dual element until acceptance tone sounds.

3. Press Size keypad (Fig. 1) and toggle to select the

single (Fig. 2) or dual (Fig. 3) element size setting.

4. To set power level press hi, med or lo keypad and if

needed toggle the hi or lo keypads to adjust to the

desired power level setting. Each touch of the hi or

lo key pad will increase or decrease the power level

by 1/2 from 9.0 through 3.0. Simmer power levels

between 3.0 and 1.2 will increase or decrease by .2

increments. Hi (Fig. 4) is the highest power level. Lo

(Fig. 5) is the lowest power level available.

5. Once cooking is ﬁ nished, press keypad to turn

the dual element OFF (Fig. 6).

DUAL RADIANT ELEMENT

The cooktop provides a dual

radiant element located as

illustrated. Use the following

instructions when operating this

element.

Use the Size keypad (Fig. 1) to select which portions

of the dual element are needed for heating. The dual

element size may be changed anytime the element is ON.

Important notes:

• If no element size is chosen when the dual element is

turned ON, only the inner coil will heat by default.

• Start most cooking operations on a higher setting and

then turn to a lower setting to ﬁ nish cooking.

• For efﬁ cient cooking, turn the surface element OFF

several minutes before cooking is complete. This will

allow residual heat to complete the cooking process.

• A glowing red surface heating area extending beyond

the bottom edge of the cookware indicates the

cookware is too small for the surface heating area.

• Radiant elements have a limiter that allows the radiant

heating element to cycle ON and OFF, even at the HI

setting. This helps prevent damage to the ceramic

cooktop. Cycling at the HI setting is normal and will

occur more often if the cookware is too small for the

radiant element or if the cookware bottom is not ﬂ at.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Frigidaire FGEF302TNF Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Küche Frigidaire FGEF302TNF