Model(indoor/outdoor):FRS093LW1/FRS093LC1FRS123LW1/FRS123LC1ac.eriadigirf.wwwmoc.eriadigirf.wwwAll about theInstallationof yourSplit Type Room Air Con
AttentionFixing the Installation PlateDrilling the Hole1. Install the installation plate horizontally over the structural parts on the wall using the
Connective pipe and drainage installationDrainage1. Run the drain hose sloping downward. Do not install the drain 2. When connecting extension drain
AttentionPiping and wrapping1. Bundle the tubing, connecting cable, and drain hose with tape 2. Because the condensed water from rear of the indoor
1. Install the outdoor part of the unit on a rigid surface to avoid excess noise and vibration.2. Direct the air vent toward an area without obstacl
Settlement of outdoor unitAnchor the outdoor unit tightly and horizontally on a concrete or rigid Fit the seal into the drain elbow, then insert the d
Flaring workMain cause for refrigerant leakage is due to defect in the flaring work.Carry out correct flaring work using the following procedure:1. C
4. Flaring work.die in the dimension shown in the table below.OUTERConnection Adjustment1. Align the pipes to be connected.OUTER TIGHTENINGCaution:
1. The inside and outside connecting cable can be connected without removing the front grille.2. Connecting cable between indoor unit and outdoor un
Electrical workCOOLING MODELHEATING AND COOLING MODEHEATING AND COOLING MODEL1 2(N) 3 41 2(N) 3 4orTerminal block of indoor unitTerminal b
04Safety precautionsDANGER! Avoid Serious Injuryor Death1. Do not attempt to install the split airconditioner by yourself.2. This air conditioner con
1. Remove the electrical control board cover from the outdoor unit by loosening the screw.2. Connect the connective cables to the terminals as ident
Electrical workCOOLING MODELHEATING AND COOLING MODELHEATING AND COOLING MODELorooror"Conector A""Conector A""Conector C”&quo
1. Never fail to have an individual power circuit specifically for the air conditioner. As for the method of wiring, be guided by the circuit diagram
Air purging with vacuum pump1. Check that each tube(both liquid and gas side tubes) between the indoor and outdoor units have been properly connected
Air purgingVacuum pumpCharge hoseManifold valve-76cm/HgChargehoseHandle LoHandle HiOutdoor unitIndoor unitWhen using the vacuum pumpFor method of usin
Electrical safetyPerform the electric safety check after completing installation:Gas leak checkSoap water methodApply a soap water or a liquid neutral
Test runningPerform test operation after completing gas leak check at the flare nutconnections and electrical safety check.1. Connect the power, pres
1. Contact a specialist to install the device.2. Guarantee that the unit is appropriately fastened and complies with all of the aforementioned safet
To prevent injury to the user or other people and property damage, the following instructions must be followed.Incorrect operation due to ignoring of
operation. It may cause electric removed, do not touch the metal parts of the unit. It may cause an injury.Safety precautionsshock or injury.and elect
078. The site must allow for the easy removal of the connector pipe and drain hose.9. The unit must be installed at a site protected from direct sun
Outdoor Unit1. The outdoor unit must be installed at a convenient site that is not exposed to strong winds. The site should be dry and well ventilate
Parts list25431Indoor unitOutdoor unitParts listInstallation plateClip anchorSealDrain Joint.12345121110811Remote controllerRemote Controller holderCo
Attention1. This illustration is for explanation purposes only.54231Indoor unitOutdoorunit6Air filterMoreABCParts list2. Copper tubes must be insula
Kommentare zu diesen Handbüchern