Frigidaire FGEF306TMF Installationsanleitung PDF herunterladen (Seite 5)

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

Four Conductor Wire Connection to Range

Where local codes does NOT permit connection of the frame

grounding conductor to the neutral wire of the copper power

supply cord (see Figure 7):

1. Remove the screws from the access plate at the lower

right end of the rear cover to expose range terminal

connection block.

2. Remove the grounding strap from the terminal block and

from the appliance frame.

3. Using the nuts supplied with the literature package,

connect the ground wire (green) of the copper power

supply cord to the frame of the appliance with the ground

screw, using the hole in the frame where the ground

strap was removed (see Figure 7).

4. Connect the neutral of the copper power supply cord to

the center silver-colored terminal of the terminal block,

and connect the other wires to the outer terminals. Match

wires and terminals by color (red wires connected to the

right terminal, black wires connected to the left terminal).

5. Replace the terminal cover and replace the screws.

Terminal Block Silver Colored Terminal

Red

Wire

Neutral

(White Wire)

Ground (Bare

Copper Wire)

To 240 V Receptacle

A User Supplied

Strain-relief Must

Be Installed at

This Location

Black Wire

1 1/8" (2.9cm)

Dia. Direct

Connection

Hole. Punch

Out Knockout for

1 3/8" (3.5cm)

Dia. Cord Kit

Hole.

NOTE: Be sure to remove the

supplied grounding strap.

Figure 7

Three Conductor Wire Connection to

Range

If local codes permit connection of the frame grounding

conductor to the neutral wire of the copper power supply cord

(see Figure 6):

1. Remove the screws from the access plate at the lower

right end of the rear cover to expose range terminal

connection block.

2. Using the nuts supplied in the literature package,

connect the neutral of the copper power supply cord to

the center silver-colored terminal of the terminal block,

and connect the other wires to the outer terminals. Match

wires and terminals by color (red wires connected to the

right terminal, black wires connected to the left terminal)

(see ﬁ gure 6).

3. Replace the terminal cover and replace the screws.

Figure 6

Silver Colored Terminal

1 1/8" (2.9 cm) Dia.

Direct Connection

Hole. Punch Out

Knockout for 1 3/8"

(3.5 cm) Dia. Cord

Kit Hole.

To 240 V

Receptacle

A User Supplied

Strain-relief Must

Be Installed at This

Location.

Black

Wire

Terminal

Block

Cord

Mounting

Plate

Neutral

(White Wire)

Grounding

Strap

Red Wire

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Frigidaire FGEF306TMF Installationsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Frigidaire FGEF306TMF